The Anti Crashing
Sensor is made from aluminum alloy
It can hold most standard plasma torch, the
inner plastic holder is 32mm width but can be
bored up to 50mm to hold other wider torch.
of Torch crash the upper part that
holding the torch bends with the torch but
still held with 3 springs, this will allow one
or the two sensors to fire back a signal to CNC Controller.
There are 2 proximity sensor connected to
torch holder, the proximity sensors can be supplied as
NO or NC and they can be powered from 10 ~ 36 VDC
Inner hole of cutting torch:
it has a clamp that can be tied with a bolt to
meet torch diameter.
Height of installation location: